1.1 INTRODUCTION

Key selector switch with direct open operation function Pin tumbler design for high security.

Workers can be limited by using key selector switch to switch modes when performing maintenance and program overwrites. Additionally, since the NC contact (b-contact) use direct open operation, the circuit will be reliably shut off by forcibly separating the NC contact, even if they have melted together.

1.2 USES

Hazards of the system and robot are isolated by the safety guard. When a worker needs to work inside the hazardous area for maintenance, the worker unlocks the safety guard using a key, disables the system from starting (1), removes the key and brings it into the hazardous area, and then changes the operation mode of each system to maintenance mode (2). While the worker is carrying out maintenance work in the hazardous area, the safety guard cannot be locked and the system cannot be turned on. This enables the worker to work safely in the hazardous area.

Specification

Mechanical Life                   : 250, 000 (Single Contact)

Operating Temperature      : -20 ~ + 55°C

Operating Humidity             : 48 ~ 85%

Store Temperature              : -45 ~ +85°C

Store Humidity                     : Below 95% RH

Insulation Resistance         : Over 100M (500V DC Megger)

Electrical Life                       : 100, 000 (Single Contact Point); 50, 000 (Double Contact Point)

Degree of Protection

In Front Panel                      : IP 65 (IEC 60529)

Terminal                               : IP 20 (IEC 60529)

Dielectric Strength

Contact Block                     : 2500 VAC/ Minutes

Indicator Light                    : 2000 VAC/ Minutes

Vibration Resistance

Mal-Operation                    : 5~55Hz single amplitude 0.5mm

Durability                             : 30Hz single amplitude 1.5mm

Shock Resistance

Mal-Operation                    : 100m/s²

Durability                            : 1,000m/s²

**INCLUDE INVOICE**